Plumber in Kingston Heights, Linthicum

The Problem

Your Kingston Heights home has had recurring sewer backups — cleared twice in the last 18 months by rooter service. Each time, you're told the line is clear and there's no camera inspection. The cycle repeats every 4–6 months.

What We Do

Recurring rooter-cleared backups without camera inspection means the company is treating the symptom. In a 1960s Kingston Heights home with clay or Orangeburg lateral, the cause is almost always root intrusion through deteriorated joints or a collapsed section that refills with debris after clearing. A camera inspection shows you exactly what's happening — whether it's a joint that can be trenchlessly lined or a collapsed section that needs replacement. You should not be in a 6-month rooter cycle.

The Problem

Water pressure throughout your Kingston Heights home has been gradually declining. Hot water has rust particles in it on cold mornings, and the pressure in the upstairs shower is noticeably weaker than it was two years ago.

What We Do

Declining pressure with rust particles is the end-stage pattern for galvanized supply pipe — the interior is scaling heavily and shedding rust under the thermocycle. The upstairs pressure is weakest because water must push through more degraded pipe length to reach the second floor. We assess the supply system and identify whether a partial repipe — replacing the worst sections — restores adequate pressure and delays full system replacement, or whether the deterioration is uniform enough to warrant doing it in one job.

The Problem

You're planning to refinish the basement of your Kingston Heights home and want to know the condition of the cast iron drain stack before putting up walls. You don't have any active backups, but you don't want to finish the space and then discover a problem.

What We Do

Camera inspection before finishing a basement is one of the most practical things a Kingston Heights homeowner can do — especially with original cast iron. We run the camera from the cleanout, inspect the stack and main line, and give you a written assessment of condition. If there's offset joints, buildup, or incipient root intrusion, you want to know and address it before the walls go up. A pre-finish inspection is far less expensive than cutting into new drywall.

The Problem

The temperature and pressure relief valve on your Kingston Heights water heater has been dripping slightly for a week. A friend said to just let it drip into the pan, but you're not sure if this is a real safety issue.

What We Do

A T&P valve that drips continuously means either the valve itself has failed (they do wear out) or the tank pressure or temperature is running above the normal setpoint. Both warrant attention — a failed valve should be replaced because it won't perform in an actual over-pressure event; a pressure or temperature issue needs diagnosis. A friend's advice to 'let it drip into the pan' ignores the underlying cause. We test the tank pressure and temperature, replace the valve, and confirm the discharge pipe terminates correctly.